> HELICOPTER > 4CH Mini Invader Helicopter

Mini Size Coaxial Helicopter 

• Rudder central Auto-Trimming : Land your heli on the ground for 3 seconds 
  and  minimum the throttle, your heli will find the rudder central autonomous.

• Alloy rugged construction withstand  from severe crash

• Little to do before flight

TX digital station display can be programmed for two types of management: beginner and expert. Within each of these type, it can be programmed different values of sensitivity for each channel, roll, elevator and rudder. from 0% to 100% in each mode, allow you to adjust the response sensitivity of the controller to your personal taste, and your level of experience.

 

•Expert Mode Setting

 

Hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder) stick for 1 second to enter the setting status,press Throttle Trim key up or down  to choose reverse,and then hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder) stick for 1 second to confirm and exit.

 

•Sensitity Programming

RUDDER SENSITIVITY SET UP- NOR MODE
Hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder)  stick for 1 second to enter the setting status,press Throttle/Rudder or(mode 1:Elevator/Rudder) key until the three-point dotted line symbol start  to flash(see picture below),press Rudder Trim to idea sensitivity and then hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder) stick for 1 second to confirm and exit.

ELEV SENSIVITY SET UP- NOR MODE
Hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder)  stick for 1 second to enter the setting status,press Throttle/Rudder or(mode 1:Elevator/Rudder) key until the three-point dotted line symbol start  to flash(see picture below),press Elevator Trim to idea sensitivity and then hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder) stick for 1 second to confirm and exit.

AILE SENSIVITY SET UP- NOR MODE
Hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder)  stick for 1 second to enter the setting status,press Throttle/Rudder or(mode 1:Elevator/Rudder) key until the three-point dotted line symbol start  to flash(see picture below),press Aileron Trim to idea sensitivity and then hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder) stick for 1 second to confirm and exit.

 

 

 

---

Can fly indoors and outdoors with a slight breeze, Can be set to go nearly as easy as a coaxial, and also to have much more flexibility and movement control for a quick flight and sport

Size:230L*80H*40Wmm
Flying Weight:60g
Flying Time:Around 8 minutes
Power system:N30 main motor*1,N20 tail rotor*1
Transmitter:4 Channels 2.4Ghz
Servo:super micro size 2.0g 0.12sec/60.
Helicopter battery:3.7V 450mAh LiPo battery with safety PCB.
Transmitter battery:4*AAA(not included)

Package:
MEAS:55x35x39CM
18pcs/ctn
G.W./N.W.:11.4/13kgs

This R/C model is not a toy!
RC model helicopter is not toy and is not suitalble for children under 14 years,Keep it away from children.Carefully read the instruction before any use,if you are beginner,its advisable to be assisted by an experienced helecopter pilot.HUBSAN HOBBY international reserves the right to modify the model without prior notice.